Erasing The Edges And Copying All (Edge Erase/Copy All) - Xerox Document Centre 706 Series User Manual

G G
Added Features
G When Copy All is selected,
depending on the type of document
used, the edges of the copies made
may contain marks or image loss
may result.
G The Edge Erase default value can
be changed by using the Tools
Mode. The factory default is Normal
(T&B, L&R: 2 mm and
Centre: 0 mm)
G No copying can be done onto the 2
mm border area of the paper.
G If you have selected Reduce/
5 Enlarge, the area for edge erase will
also be reduced/enlarged.
G If you have selected Book Copying,
Edge Erase will be based on the
entire image of the document.
G If you have also selected Multi-Up
(N Up) and Centre Erase, then
Edge Erase will be based on the
individual original image.
102

5-8 Erasing the Edges and Copying All (Edge Erase/Copy All)

Erasing the Edges and
Copying All
When copying with the document cover open or when copying bound
documents, shadows are sometimes found at the edges or centre of the
copies made. These shadows can be erased with the feature, Edge Erase.
It is also possible to make a copy without erasing these shadows by
selecting Copy All.
G Erasing the shadows of documents (Edge Erase)
Set the amount of erase of shadows on the top, bottom, left, or right,
centre of the document. The part which Edge Erase is set will not be
copied (that is, will be erased).
G Copying onto whole area of paper (Copy All)
Amount of erase is 0 mm, and the entire page is copied.
(Edge Erase/Copy All)