Rep 1.3 Top Cover Interlock; Rep 1.4 Developer Fan - Xerox Phaser 790 Service Manual

REP 1.3 Top Cover Interlock

Parts List on PL 11.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Top Cover Assembly (REP 14.4).
3. Remove the Rear Cover (REP 14.6).
4. Remove the Top Cover Interlock (Figure 1).
Replacement
1. Reinstall the Top Cover Interlock in the reverse order of removal.
2
Remove the screw
Figure 1 Removing the Top Cover Interlock
Repairs and Adjustments
REP 1.3, REP 1.4
WARNING
3
Remove the
Top Cover
Interlock
1
Disconnect the
connector

REP 1.4 Developer Fan

Parts List on PL 11.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Rear Cover (REP 14.6).
3. Remove the Developer Fan (Figure 1).
Replacement
Install the Developer Fan so that the manufacturer's label on the surface faces towards the out-
side.
1. Attach the harness securely when reinstalling the Developer Fan.
2. Reinstall the Developer Fan in the reverse order of removal.
3
Remove the
Developer Fan
1
Disconnect the connec-
tor. Then, disengage the
harness from the duct
Figure 1 Removing the Developer Fan
10/00
4-6
WARNING
CAUTION
2
Spread the fan
duct hooks
Phaser 790/DocuColor 2006
Initial Issue