Rep 8.8 Tray Housing; Rep 8.9 Main Paper Handling Frame Assembly - Xerox Phaser 790 Service Manual

REP 8.8 Tray Housing

Parts List on PL 4.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Bypass Tray/Registration Assembly. (REP 8.6)
3. Remove the Bypass Tray Feed Assembly. (REP 8.7)
4. Remove the Tray Housing. (Figure 1).
3
1
Remove the front arm of the Tray Housing
Disconnect the
from the Bypass Tray Assembly and remove
connector
the Tray Housing
Figure 1 Removing the Tray Housing
Replacement
1. Install from the front arm, while being careful not to pinch the harness.
Initial Issue
Phaser 790/DocuColor 2006
WARNING
2
Remove the rear arm of the
Tray Housing by pushing on the
housing tray arm until the boss
is free from its retaining hole

REP 8.9 Main Paper Handling Frame Assembly

Parts List on PL 4.6
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Bypass Tray/Registration Assembly. (REP 8.6)
3. Remove the Main Paper Handling Frame Assembly. (Figure 1)
2
Remove the two screws from
the top side and remove the
Bypass Tray Feed Assembly
Main Paper
Handling Frame
Assembly
Figure 1 Removing the Main Paper Handling Frame Assembly
Replacement
1. Perform the procedure for removal in reverse.
10/00
4-65
WARNING
3
Remove the screws
from each end and
separate the Main
Paper Handling
Frame Assembly
1
Disconnect the two connectors on the underside
and one at the opposite end of the assembly
Repairs and Adjustments
REP 8.8, REP 8.9