Rep 9.6 Waste Toner Sensor; Rep 9.7 Toner Box Sensor - Xerox Phaser 790 Service Manual

REP 9.6 Waste Toner Sensor

Parts List on PL 5.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Locating Rail (REP 9.5).
3. Remove the Waste Toner Sensor (Figure 1).
Replacement
1. Remove all slack from the harness before securing the harness.
2. Reinstall the Waste Toner Sensor in the reverse order of removal.
2
Unhook the sensor from the
rail
3
Remove the
Waste Toner
Sensor
1
Disconnect the connector
Figure 1 Removing the Waste Toner Sensor
Repairs and Adjustments
REP 9.6, REP 9.7
WARNING

REP 9.7 Toner Box Sensor

Parts List on PL 5.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Locating Rail (REP 9.5).
3. Remove the Toner Box Sensor (Figure 1).
Replacement
1. Remove all slack from the harness before securing the harness.
2. Reinstall the Toner Box Sensor in the reverse order of removal.
4
Remove the Toner
Box Sensor
1
Disengage the harness
from the clamp
Figure 1 Removing the Toner Box Sensor
10/00
4-96
WARNING
3
Unhook the sensor from
the rail
2
Disconnect the connector
Phaser 790/DocuColor 2006
Initial Issue