Rep 6.7 Registration Sensor - Xerox Phaser 790 Service Manual

REP 6.7 Registration Sensor

Parts List on PL 16.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Left Cover (REP 6.3).
3. Remove the Rear Cover (REP 6.4)
4. Remove the bracket, containing the power receptacles. (Figure 1)
1
Remove the screws
(2) and the bracket,
containing the power
receptacles
Figure 1 Removing the Bracket and Power Receptacles
Repairs and Adjustments
REP 6.7
WARNING
5. Remove the Registration Sensor (Figure 2).
1
Remove the screw
Figure 2 Removing the Registration Sensor
Replacement
1. Perform the procedure for removal in reverse.
10/00
4-40
3
Remove the Registration
Sensor
2
Disconnect the
connector
Initial Issue
Phaser 790/DocuColor 2006