Rep 10.13 Exchange Chute - Xerox Phaser 790 Service Manual

REP 10.13 Exchange Chute

Parts List on PL 8.4
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Exit Tray Assembly (REP 8.30).
3. Remove the Fuser Assembly (REP 10.1).
4. Remove the Main Fuser Assembly (REP 10.2).
Be careful not to damage the front or rear hinges of the Exchange Chute while removing the
chute.
5. Remove the Exchange Chute (Figure 1).
Replacement
Insert the U-shaped parts on the front and rear of the Exchange Chute securely into the
plunger when installing the chute.
1. Reinstall the Exchange Chute in the reverse order of removal.
Repairs and Adjustments
REP 10.13
WARNING
CAUTION
CAUTION
3
Remove the screw.
Then, remove the
Front Exchange
Stopper
4
Remove the screw
and the Rear
Exchange Stopper
2
Remove the
Fuser Front Rail
1
Remove the
screws
Figure 1 Removing the Exchange Chute
10/00
4-122
5
Remove the
Exchange Chute
from the right side
Initial Issue
Phaser 790/DocuColor 2006