Rep 8.17 Registration Clutch; Rep 8.18 Registration Rubber Roll - Xerox Phaser 790 Service Manual

REP 8.17 Registration Clutch

Parts List on PL 4.7
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Bypass Tray/Registration Assembly. (REP 8.6)
3. Remove the Main Paper Handling Assembly. (REP 8.9)
4. Remove the Registration Clutch. (Figure 1)
Figure 1 Removing the Registration Clutch
Replacement
1. Perform the procedure for removal in reverse.
Repairs and Adjustments
REP 8.17, REP 8.18
WARNING
1
Disconnect the
connector
2
Remove the E-
ring and remove
the Registration
Clutch

REP 8.18 Registration Rubber Roll

Parts List on PL 4.7
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Bypass Tray/Registration Assembly. (REP 8.6)
3. Remove the Main Paper Handling Assembly. (REP 8.9)
4. Remove the Registration Clutch. (REP 8.17)
5. Remove the Registration Rubber Roll. (Figure 1)
2
Remove the E-ring, gear and bearing
Figure 1 Removing the Registration Rubber Roll
Replacement
1. Perform the procedure for removal in reverse.
10/00
4-70
WARNING
3
Remove the Registration
Rubber Roll
Phaser 790/DocuColor 2006
1
Remove the
bearing
Initial Issue