Do An Extended Scan-To-File Job - Oce TDS400-CS User Manual

Do an extended scan-to-file job

Introduction
This section describes a general workflow for an extended scan-to-file job.
Before you begin
If you must enter the same value for a setting very often, you can set this value
as the default value for that setting in the Océ Settings Editor.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the printer
queue of the Océ Queue Manager, a scan-to-file job appears in the selected
destination of the Océ Scan Manager.
How to do an extended scan-to-file job on the Océ TDS400-CS
Place the original face down and right aligned.
1.
The scanner takes the original.
[50] Place the original face down and right aligned
[50] Place the original face down and right aligned
218 User manual