Make A Copy And Delete A Specific Area Of An Original - Oce TDS400-CS User Manual

Make a copy and delete a specific area of an original

Introduction
You can make a copy without a specific area of an original with the 'Delete
area' setting.
Attention:
copied all the required information.
How to copy a specific area of an original
Place the original face down and right aligned.
1.
The scanner takes the original.
Define the job settings.
2.
[46] The icons of 'Y Offset', 'X Offset','Width' and 'Length' setting
[46] The icons of 'Y Offset', 'X Offset','Width' and 'Length' setting
Select 'Copy' with the upper-left softkey.
The copy job templates appear.
Open a copy job template with a left softkey.
The top 5 settings appears.
Scroll to 'Delete area' and open this setting with the left softkey.
Define the 'X Offset' with the scroll wheel or numeric keys.
Select 'Y Offset' with the left softkey and define the value with the scroll
wheel or numeric keys.
Select 'Width' with the left softkey and define the value with the scroll wheel
or numeric keys.
Select 'Length' with the left softkey and define the value with the scroll
wheel or numeric keys and close the setting.
Define the number of copies if necessary and press the green start key.
3.
Result
The Océ TDS400-CS copies an original without the specified area.
Copy jobs
When you copy without a specific area, make sure that you
207