Handle errors at the reinforcement unit
No reinforcement strips on the output
Introduction
When there is no reinforcement strip on the output, then
The reinforcement strip is not correctly installed, or
The reinforcement strip is not available.
Install a new reinforcement strip
Press the On-line key on the operator panel to put the printer off-line.
1.
Open the side door of the reinforcement unit.
2.
Check for loose reinforcement strips in the unit with the protection sheet on
3.
(see situation B in figure 118).
[93] Situation A: No mechanical error. Situation B: Mechanical error.
[93] Situation A: No mechanical error. Situation B: Mechanical error.
Maintain the Océ TDS400-CS
285