Oce TDS400-CS User Manual page 257

Feed the media between the input guide plates against the rollers.
7.
Turn the rollers until the media is visible. Also refer to the label inside the
8.
drawer.
[72] Feed the media
[72] Feed the media
If you inserted a roll with another media or with a different width, you must
9.
program the correct width and media type. If you need to cut the paper to get
a straight leading strip, select 'Cut media'
Close the lower media compartment.
10.
Press the On-line key.
11.
Maintain the Océ TDS400-CS 257