Define The Automatic Original Feed Setting - Oce TDS400-CS User Manual

Define the automatic original feed setting

Introduction
This setting provides an easy method to feed a set of originals, because you
only need to press the start key once. If you use this setting you can also define
the original feed time-out.
Before you begin
Open the Océ Settings Editor and log on as Key Operator. Take the following
steps to log on.
Click 'File' and select 'Log on'.
1.
Select 'Key operator' and enter the password.
2.
How to define the auto original feed settings
Click 'View' and select 'KO settings'.
1.
Navigate to 'KO - Scanner - Original handling - Auto original feed'
2.
Select 'On'
3.
Define the original feed time-out if necessary.
4.
Click 'Apply' to confirm the settings.
5.
Click 'File' and select 'Log off' to prevent unauthorised use.
6.
You can also define the auto original feed setting at the scanner operator
Note:
panel. Select 'System' - 'Auto feed' - 'On'.
Result
Feed a set of originals in a more productive way.
Set up your workflow with the Océ Power Logic® controller applications 135