Table of Contents
Advertisement
System message
'Printer asleep'
'Please wait'
'Printer ready'
'Preparing job'
'Load roll 1'
'A2'
'Paper'
'Load roll 2'
'A2'
'Paper'
'Manual feed'
'Conditioning'
'Printer ready'
'Roll 1 empty'
'Printer ready'
'Roll 2 empty'
'Printer running'
'Roll 1 empty'
'Printer running'
'Roll 2 empty'
'Job cancelled'
'Close roll unit'
'Sensor not free'
'Remove paper'
'Press <on-line>'
'Paper retracted'
'Press <on-line>'
'Copy too short'
'Remove paper'
'Press <on-line>'
268
User manual
Description / solution
The printer is in low power mode to save energy.
The printer downloads the language.
The printer is ready to print.
The printer prepares a copy or print job.
The required media is not loaded on roll 1. Load the required media.
(see 'Load the media' on page 252)
The required media is not loaded on roll 2. Load the required media.
(see 'Load the media' on page 252)
The required media is not found. Feed the required media at the
manual feed table.
(see 'Make a copy on a cut sheet' on page 199)
The printer optimizes the toner concentration. Please wait.
Media roll 1 is empty. Reload roll 1.
(see 'Load the media' on page 252)
Media roll 1 is empty. Reload roll 1.
(see 'Load the media' on page 252)
Media roll 1 is empty. Reload roll 1 when the printer is ready.
(see 'Load the media' on page 252)
Media roll 2 is empty. Reload roll 1 when the printer is ready.
(see 'Load the media' on page 252)
The active print or copy job is cancelled.
The roll unit is open. Close the roll unit.
The media of a roll was not in the start position while the printer was
turned on. Turn the media back into the start position and press on
line.
The cut sheet was retracted. Feed the cut sheet at the manual feed
table.
Use an original longer than 420 mm.
Advertisement
Table of Contents
