Make a copy of a specific area of an original
Introduction
You can make a copy of a specific area of an original with the 'Remove strip'
setting. Define the following strips to specify the area.
'Leading'
'Trailing'
'Left'
'Right'
Before you begin
If you must enter the same value for a setting very often, you can set this value
as the default value for that setting in the Océ Settings Editor.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the printer
queue of the Océ Queue Manager, a scan-to-file job appears in the selected
destination of the Océ Scan Manager.
Attention:
required information.
Copy jobs
When you remove a strip, make sure that you copied all the
205