Do an extended scan-to-file job
Introduction
This section describes a general workflow for an extended scan-to-file job.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the
default value for that setting in the Océ Settings Editor.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the printer queue of
the Océ Queue Manager, a scan-to-file job appears in the selected destination of the
Océ Scan Manager.
How to do an extended scan-to-file job on the Océ TCS500
Place the original face down and right aligned.
1.
The scanner takes the original.
[99]
[99] Place the original face down and right aligned
Select 'Scan-to-file' with the upper-left softkey.
2.
The scan-to-file job templates appear.
Define the job settings.
3.
Do an extended scan-to-file job
133