Define the subnet mask
Introduction
Use the following procedure to define the subnet mask.
If the DHCP server is defined, you can skip this procedure.
Note:
Before you begin
Use the
'next/select' key to select a menu or a value.
How to define the subnet mask
Make sure you have access to the system settings.
1.
(see 'Access the system settings in the system menu' on page 119)
Navigate to 'Network settings' and select this menu.
2.
Navigate to 'Adapter 2' and select this menu.
3.
Navigate to 'Subnet mask' and select this menu.
4.
The first three digits flash.
Enter the first three numbers with the
5.
and press the 'next/select' key to confirm the value.
The next three digits flash.
Enter the next three numbers with the
6.
and press the 'next/select' key to confirm the value.
The next three digits flash.
Enter the next three numbers with the
7.
and press the 'next/select' key to confirm the value.
The next three digits flash.
Enter the next three numbers with the
8.
and press the 'next/select' key to confirm the value.
The next three digits flash.
Navigate to the next network setting or press the 'on-line' key to turn the printer
9.
on-line again.
Result
The subnet mask is defined.
122
User manual
key, the
key and the 'previous' key to navigate. Use the
key and the
key
key and the
key
key and the
key
key and the
key