Do An Extended Copy Job - Oce TDS400-CS User Manual

Do an extended copy job

Introduction
The main steps of an extended copy job are the following.
Feed the original.
Define the job settings.
Press the green start key.
Before you begin
If you must enter the same value for a setting very often, you can set this value
as the default value for that setting in the Océ Settings Editor.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the printer
queue of the Océ Queue Manager, a scan-to-file job appears in the selected
destination of the Océ Scan Manager.
How to copy on the Océ TDS400-CS
Place the original face down and right aligned.
1.
The scanner takes the original.
[37] Place the original face down and right aligned
[37] Place the original face down and right aligned
182 User manual