Oce TDS400-CS User Manual page 265

The error messages
Error message
'Copy too late'
'Remove paper'
'Press <on-line>'
'Speed failure'
'Remove paper'
'Press <on-line>'
'Knife 1 error'
'Remove paper'
'Press <on-line>'
'Knife 2 error'
'Remove paper'
'Press <on-line>'
'Roll retract err'
'Press <on-line>'
'Roll init error'
'Open roll unit'
'Press <on-line>'
'Input too late'
'Open roll unit'
'Press <on-line>'
'Deposit error'
'Press <on-line>'
Maintain the Océ TDS400-CS
Description / solution
A media jam occurred. Remove the stuck media and
press on-line.
(see 'Clear media jam in the media feed section of
the printer' on page 270)
(see 'Clear media jam in the fuser section' on
page 271)
A media jam occurred. Remove the stuck media and
press on-line.
(see 'Clear media jam in the media feed section of
the printer' on page 270)
(see 'Clear media jam in the fuser section' on
page 271)
An error occurred during the cut of the roll. Check
the media on roll 1 and remove scrapped media if
necessary. Press on-line.
(see 'Load the media' on page 252)
An error occurred during the cut of the roll. Check
the media on roll 1 and remove scrapped media if
necessary. Press on-line
(see 'Load the media' on page 252)
A media roll error. Check the media on the rolls and
press on-line.
(see 'Load the media' on page 252)
The media of a roll was not in the start position while
the printer was turned on. Place the media back into
the start position and press on line.
(see 'Load the media' on page 252)
The input sheet is too late. Open the roll unit,
withdraw roll and rewind. Press on-line
An error occurred in the compact output stacker. The
compact output stacker stops. The print process
continues.
Press <on-line>.
265