Chapter 1 - Oce TDS400-CS User Manual

Chapter 14

Maintain the Océ TDS400-CS
Clear the set memory 244
Maintain the Océ TCS4 scanner 246
Clear an original jam 246
Scanner error-messages and solutions 247
Calibrate the scanner 248
Clean the scan area 250
Maintain the Océ TDS400 printer 252
Media 252
Toner 262
Handle media jams at the Océ TDS400 printer 264
Maintain the finishing options 273
The reinforcement unit 273
Handle errors at the reinforcement unit 285
Handle media jams at the folder 289
Appendix A
System specifications 297
Specifications Océ TCS4 scanner 298
Original types for the Océ TCS4 scanner 300
Specifications Océ Power Logic® controller 302
Specifications Océ TDS400 printer 304
Supported media types and sizes for the Océ TDS400 printer 305
Available media types 305
Available media sizes 307
Standard scale factor 309
Specifications Océ Scan Logic® 311
Specifications drivers and job submission software 313
Appendix B
Miscellaneous 315
Reader's comment sheet 316
Addresses of local Océ organisations 318
10 User manual
Load the media 252
Define the media type and media size 258
Cut the media 260
Define the media series of the Océ TDS400 printer 261
Refill the toner 262
Printer error-messages and solutions 264
Printer system-messages and solutions 267
Clear media jam in the media feed section of the printer 270
Clear media jam in the fuser section 271
Insert a new tape roll 273
Empty the waste box 281
Clean the reinforcement knives 283
No reinforcement strips on the output 285
Clear tape jam in the reinforcement unit 287
Clear media jams in the folder 289