Oce TDS400-CS User Manual page 215

Define job settings with the left soft keys and the scroll wheel
Select 'Copy' or 'Scan-to-file' with the upper-left softkey.
1.
The five job templates appear.
Select a job template with one of the left softkeys.
2.
The top 5 settings appear.
Find a setting with the scroll wheel.
3.
A small rectangle in front of a setting name indicates the focus of the scroll
wheel.
Select a setting with the left softkey.
4.
There are several types of settings. The behaviour of the scanner operator panel
and the definition of a setting depends on the type of setting you selected. You
can select one of the following types of settings.
A setting that contains two values only, like 'On' or ' Off'.
When you select this setting while the setting was not in focus, the setting
becomes in focus. When you select this setting while the setting was already
in focus, the setting stays in focus and there are no changes.
Change the value of the setting with the left softkey. The value and icon
changes.
A setting that contains a list of values, like 'Lighter/darker'.
Define the required value with the scroll wheel. The value and icon changes.
A setting that contains a list of settings, like 'Media'.
Define the required value with the scroll wheel. The value and icon changes.
Select the next setting of the list of settings with the left softkey.
You can enter a numeric value with the numeric keys. To enter a negative
Note:
numeric value, scroll to a negative value first and than enter the value with the
numeric keys.
Select 'Close' with the lower-right softkey.
5.
Repeat from step 4 to define the next setting.
6.
Use the 'Defaults' option at the lower-left key to set all settings of the job
Note:
template to default.
Scan-to-file jobs 215