Proper Disposal Of A Drum Unit - Printronix L5535 Maintenance Manual

Never force the drum onto the shaft. If it feels as though the drum is not
seating properly, remove the drum and inspect the shaft for foreign
material or burrs.
21. Remove the drum auxiliary rod from the drum shaft.
22. Reinstall the nut and tighten it securely by hand on the drum shaft.
23. Reinstall the lower inner cover and secure it with the two screws you
removed from it earlier.
24. Reinstall the drum plate and tighten the thumbscrews. While installing the
drum plate, place your thumb over the copper grounding clip and hold it in
place. Otherwise the grounding clip can be bent, making no contact with
the drum shaft.
25. After installing the drum plate, visually verify good electrical contact
between the copper grounding clip and the end of the drum shaft.
Alternatively, measure the resistance. Connect one lead of an ohmmeter
to the bracket on the drum plate, and touch the other lead to the edge of
the drum. Normal resistance should be 0Ω.
26. Reinstall the developing unit. (See the User's Manual .)
27. Raise the transport unit by reversing step 10.
28. Reinstall the upper inner cover and tighten the thumbscrews.
29. Close the waste toner recovery unit and ensure that it latches.
30. Close the printer front cover.

Proper Disposal Of A Drum Unit

Due to the nature of the material used in drum manufacturing, federal
regulations prohibit inappropriate disposal of laser print drums. Dispose of
used drums by shipping them to one of the following:
Within U.S.A.
U.S. Fuji Electric, Inc.
240 Circle Drive
Piscataway, NJ 08854
Attn: Russell Robbins
Phone: (732) 560-9410
Outside U.S.A.
Fuji Electric GmbH
Mr. Takeshi Kusaba, President (Mr. Kazumasa Ozawa, Manager)
Lyoner Str. 26
D-60528 Frankfurt am Main,
Germany
TEL: (069) 669-0290
FAX: (069) 666-1020
Proper Disposal Of A Drum Unit
I–259