Exhaust Fan
(Figure 6–23)
Removal
1. Disconnect the AC power cord from the rear of the printer. Open the top
cover.
2. Remove the right side panel as described on page 6–4.
3. Remove four screws (1) and the fan muffler (2).
4. Disconnect the fan connector (3).
5. Remove four screws (4), washers (5), and the fan (6).
Installation
1. Install the exhaust fan, four washers (5), and screws (4).
2. Connect the fan connector.
3. Install the fan muffler and four screws (1).
4. Install the right side panel as described on page 6–4.
5. Connect the AC power cord and close the top cover.
6–70
Replacement Procedures