Snmp-Server V3-Host - Cisco Small Business 200 Series User Manual
Advanced smart switch command line reference
Hide thumbs
Also See for Small Business 200 Series:
- Administration manual (337 pages) ,
- Quick start manual (72 pages) ,
- Administration manual (283 pages)
Table of Contents
Advertisement
SNMP
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Command Modes
Global Config
Related Commands
Command
snmp-server v3-
host
snmp-server v3-host
Use this command to specify the recipient of Simple Network Management
Protocol Version 3 notifications. To remove the specified host, use the no form of
this command.
snmp-server v3-host {ip-address | hostname} username traps
][
priv
udpport port
no snmp-server v3-host {ip-address | hostname} traps
Syntax Descriptions
Parameter
ip-address
Hostname
username
traps
Noauth
Auth
Priv
port
Description
Specifies the recipient of Simple Network Management
Protocol Version 3 notifications.
]
Description
The IP address of the host (i.e., the targeted recipient).
The name of the host. The range is 1–158 characters.
The user name used to generate the notification. (30
characters maximum.)
Indicates that SNMP traps are sent to this host.
Specifies sending of a packet without authentication.
Specifies authentication of a packet without encrypting it.
Specifies authentication and encryption of a packet.
The UDP port of the host to use. The range is 1025–65535.
The default is 162.
11
[
noauth | auth |
423
Advertisement
Table of Contents
