VLAN Management
VLAN
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Related Commands
Command
switchport
general
acceptable-
frame-type
tagged-only
switchport
general pvid
switchport general pvid
Use this command to configure the Port VLAN ID (PVID) when the interface is in
general mode. (Use the switchport mode general command to set the VLAN
membership mode of a port to general.) To configure the default value, use the
no form of this command. The VLAN ID might belong to a non-existent VLAN.
switchport general pvid vlan-id
no switchport general pvid vlan-id
Syntax Descriptions
Parameter
vlan-id
Default
The default PVID is 1. If the VLAN ID is non-existent, then VLAN ID is set to the
reserved VLAN, 4094.
Command Modes
Interface Config
Description
Configures the Acceptable Frame Type to Admit Only
VLAN Tagged for a General Port.
Configures the Port VLAN ID (PVID) when the interface is in
general mode.
Description
The VLAN ID to be used as the PVID.
4
222