Auto-Voip - Cisco Small Business 200 Series User Manual

VLAN Management

Auto-VoIP

Auto-VoIP
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Examples
The following command shows LLDP remote device information received on port
e7.
(Switch) #show lldp remote-device detail e7
LLDP Remote Device Detail Local Interface: e7
Remote Identifier: 2
Chassis ID Subtype: MAC Address
Chassis ID: 00:FC:E3:90:01:0F
Port ID Subtype: MAC Address
Port ID: 00:FC:E3:90:01:11
System Name:
System Description:
Port Description:
System Capabilities Supported:
System Capabilities Enabled: Time to Live: 24 seconds
Related Commands
Command
show lldp med
remote-device
The Auto-VoIP feature identifies voice-over-Internet Protocol streams in Ethernet
switches and provides them with a better class-of-service (CoS) than ordinary
traffic. The switch supports two types of Auto-VoIP:
• Protocol-based—Identifies a VoIP session using the Session Initiation
Protocol (SIP) and H.323 control traffic, and assigns these packets the
highest priority on the voice VLAN.
• OUI-based—Defines an Organizationally Unique Identifier (OUI, the first
three bytes of the MAC address) to be detected in client packets and
assigns the configured priority value.
This section describes how to configure Auto-VoIP.
Description
Displays the summary information about remote devices
that transmit current LLDP-MED data to the system.
4
242