Storm-Control Unicast - Cisco Small Business 200 Series User Manual

Port Management
Flow Control and Storm Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Related Commands
Command
storm-control
multicast
storm-control
multicast rate
show storm-
control

storm-control unicast

This command enables unicast storm recovery mode for an interface. If the unicast
storm recovery is active and the rate of destination lookup failure packets
ingressing on an interface exceeds the configured threshold, the traffic is
dropped.
Use the no form of the command to disable this feature.
storm-control unicast
no storm-control unicast
Default
Unicast storm recovery mode is disabled.
Command Modes
Interface Config
Global Config
Related Commands
Command
storm-control
unicast level
storm-control
unicast rate
Description
Enables multicast storm recovery mode for an interface or
all interfaces.
Configures the multicast storm recovery threshold for an
interface or all interfaces.
Shows storm control configuration on a port or on all ports.
Description
Configures the unicast storm recovery threshold for an
interface or all interfaces.
Configures the unicast storm recovery threshold for an
interface or all interfaces.
3
195