Management Access Lists; Deny - Cisco Small Business 200 Series User Manual

Administration
Switch Management Access Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Examples
The following shows sample output for the command:
switch#show serial
Serial Port Login Timeout (minutes)............ 5
Baud Rate (bps)................................ 115200
Character Size (bits).......................... 8
Stop Bits...................................... 1
Parity......................................... none
Related Commands
Command
show network
show serial

Management Access Lists

deny

Use this command in Management Access-List Config mode to set conditions for
the management access list. This command can take the following forms:
deny interface interface [service service] [priority priority]
deny ip-source ip-address [mask mask | prefix-length] [service service] [priority
priority]
deny user username [priority priority]
Syntax Descriptions
Parameter
interface
service
priority
Description
Displays configuration settings associated with the
switch's management interface.
Displays configuration settings associated with the
switch's serial console interface.
Description
A port number.
The service type: telnet, http, tftp, ssh, or snmp.
Priority for the rule. The range is 1–16.
2
91