Cisco Small Business 200 Series User Manual page 43

Administration
PoE
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Syntax Descriptions
Parameter
dot3af
user-def
lldp-med
Modes
Global Config
Interface Config
Default
PoE power is limit by the port. The value is 16.2 watts.
Usage Guidelines
The keywords lldp-med and dot3af, and the keywords lldp-med and user-def,
can be enabled simultaneously. If an LLDP-MED TLV is received from the powered
device, that value is given priority over a dot3af or user-defined value.
If only lldp-med is enabled, and no LLDP-MED TLV is received from the powered
device, then the default value of 16.2 watts is configured.
Related Commands
Command
poe power
management
Description
The maximum power that can be delivered by the PSE
port is limited by the detected IEEE 802.3af class.
The maximum power that can be delivered by the PSE
port is specified by the user. The value can be in the range
of 3W (3000) to 16.2W (16200).
The maximum power that can be delivered by the PSE
port is limited by the value in LLDP-MED TLVs received
from a powered device. The value specified by the
powered device should be in the range of 3–16.2 watts. If
it is not in the range, then the default value of 16.2 watts is
configured, unless the dot3af is specified or a different
user-defined value is configured.
Description
Sets the power management as dynamic or static.
2
43