Show Fiber-Ports Optical-Transceiver - Cisco Small Business 200 Series User Manual

Administration
Cable Diagnostics
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Failure Location
Related Commands
Command
show fiber-ports
optical
transceiver

show fiber-ports optical-transceiver

Use this command to display diagnostics for optical transceivers.
show fiber-ports optical-transceiver [interface]
Syntax Descriptions
Parameter
interface
Command Modes
Privileged Exec
Examples
The following example shows output for the command when no port is specified.
Output Input
Port Temp Voltage
[C] [Volt]
------- ---- -------
g1 0.4 0.000
g2 0.9 0.000
Temp - Internally measured transceiver temperatures.
Voltage - Internally measured supply voltage.
Current - Measured TX bias current.
Output Power - Measured optical output power relative to 1mW.
Input Power - Measured optical power received relative to 1mW.
TX Fault - Transmitter fault.
LOS - Loss of signal.
The estimated distance in meters from end of the cable to
the failure location. The failure location is valid only if the
cable status is Open or Short.
Description
Displays diagnostic information for optical transceivers.
Description
The port number.
Current Power
[mA] [dBm]
------- -------
3081249.3 54.887
3081249.3 54.887
Power TX LOS
[dBm] Fault
------- ----- ---
50.502 Yes No
50.502 Yes No
2
37