Show Trapflags - Cisco Small Business 200 Series User Manual
Advanced smart switch command line reference
Hide thumbs
Also See for Small Business 200 Series:
- Administration manual (337 pages) ,
- Quick start manual (72 pages) ,
- Quick start manual (13 pages)
Table of Contents
Advertisement
SNMP
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
show trapflags
This command displays trap conditions.
show trapflags
Command Modes
Privileged Exec
Examples
The following shows sample output for the command.
(switch) #show trapflags
Authentication Flag............................ Enable
Link Up/Down Flag.............................. Enable
Multiple Users Flag............................ Enable
Spanning Tree Flag............................. Enable
Authentication
Flag
Link Up/Down
Flag
Multiple Users
Flag
Spanning Tree
Flag
Related Commands
Command
snmp-server
enable traps
authentication
snmp-server
enable traps
linkmode
Indicates whether traps are sent when an SNMP user fails to
authenticate to the switch. The default is Enable.
Indicates whether link status traps will be sent. The default
is Enable.
Indicates whether a trap will be sent when the same user ID
is logged into the switch more than once at the same time
(either through Telnet or the serial port). The default is
Enable.
Indicates whether spanning tree traps are sent. The default
is Enable.
Description
Enables an Authentication Fail trap.
Enables Link Up/Down traps for the entire switch.
11
427
Advertisement
Table of Contents
