Multicast
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Related Commands
Command
show
igmpsnooping
set igmp groupmembership-interval
Use this command to set the IGMP Group Membership Interval time on a VLAN.
The Group Membership Interval time is the amount of time in seconds that a
switch waits for a report from a particular group on a specific interface before
deleting the interface from the entry. Use the no form of the command to reset it to
the default value.
set igmp groupmembership-interval vlan-id 2-3600
no set igmp groupmembership-interval vlan-id 2-3600
Syntax Descriptions
Parameter
vlan-id
Group
Membership
Interval
Default
group membership interval—260 seconds
Command Modes
VLAN Config
Description
Displays IGMP Snooping information. Configured
information is displayed whether or not IGMP Snooping is
enabled.
Description
The ID of the VLAN to configure in fast-leave mode.
The interval from 2 to 3600 seconds.
7
304