Http Access; Ip Http Port - Cisco Small Business 200 Series User Manual

Administration
Switch Management Access Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Usage Guidelines
The management interface is the logical interface used for in-band connectivity
with the switch via any of the front panel ports. The configuration parameters
associated with the switch management interface do not affect the configuration
of the front panel ports through which traffic is switched. The management
interface is always considered to be up, whether or not any member ports are up;
therefore, the show network command will always show Interface Status as Up.
Examples
The following shows sample output for the command
(switch) #show network
Interface Status............................... Always Up
IP Address..................................... 10.131.12.78
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.131.12.1
IPv6 Administrative Mode....................... Enabled
IPv6 Prefix is ................................ fe80::205:5ff:fe0a:201/64
Burned In MAC Address.......................... 00:05:05:0A:02:01
Configured IPv4 Protocol....................... DHCP
Configured IPv6 Protocol....................... None
IPv6 AutoConfig Mode........................... Disabled
Management VLAN ID............................. 1

HTTP Access

The following commands configure user access to the management interface
through HTTP.

ip http port

Use this command to specify the TCP port for use by a web browser to configure
the switch. To use the default TCP port, use the no form of this command.
ip http port 1025-65535
no ip http port
Syntax Descriptions
Parameter
1025-65535
Description
The HTTP protocol port number.
2
73