Config Router Ospf Interface Areaid; Config Router Ospf Interface Authtypekey; Config Router Ospf Interface Interval Dead - NETGEAR GSM7324 Reference Manual

7000 Series L3 Managed Switch Reference Manual for Software v1.0

config router ospf interface areaid

This command sets the OSPF area to which the specified router interface belongs. The value for
<areaid> is an IP address, formatted as a 4-digit dotted-decimal number that uniquely identifies the
area to which the interface connects. Assigning an area id, which does not exist on an interface,
causes the area to be created with default values.
Format

config router ospf interface authtypekey

This command sets the OSPF Authentication Type and Key for the specified interface.
The value of <type> is either none or simple. The [key] is composed of standard displayable, non-
control keystrokes from a Standard 101/102-key keyboard. The authentication key must be 8 bytes
or less if the authentication type is simple password. If the key is cryptographic, the key may be up
to 256 bytes.
Default
Default
Format

config router ospf interface interval dead

This command sets the OSPF dead interval for the specified interface.
The value for <seconds> is a valid positive integer, which represents the length of time in seconds
that a router's Hello packets have not been seen before its neighbor routers declare that the router is
down. The value for the length of time must be the same for all routers attached to a common
network. This value should be some multiple of the Hello Interval (i.e. 4).
Valid values range for <seconds> is from 1 to 2147483647.
Default
Format
8-12
config router ospf interface areaid
<slot.prot> <areaid>
The default authentication type is none.
The default password key is not configured. Unauthenticated
interfaces do not need an authentication key.
config router ospf interface authtypekey
<slot.port> <none/simple> [key]
40
config router ospf interface interval dead
<slot.port > <1-2147483647>
May 30, 2003 Beta Draft
Routing Commands