Ip Igmpsnooping Groupmembership-Interval - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
13.1.2.1 no ip igmpsnooping interfacemode
This command disables IGMP Snooping on all interfaces.
Format
Mode

13.1.3 ip igmpsnooping groupmembership-interval

This command sets the IGMP Group Membership Interval time on a VLAN, one interface
or all interfaces. The Group Membership Interval time is the amount of time in seconds
that a switch waits for a report from a particular group on a particular interface before
deleting the interface from the entry. This value must be greater than the IGMPv3
Maximum Response time value. The range is 2 to 3600 seconds.
Default
Format
Modes
13.1.3.1 no ip igmpsnooping groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
Format
Modes
IGMP Snooping Commands
no ip igmpsnooping interfacemode
Global Config
260 seconds
ip igmpsnooping groupmembership-interval <vlanId>
<2-3600>
Interface Config
Global Config
VLAN Mode
no ip igmpsnooping groupmembership-interval
Interface Config
Global Config
VLAN Mode
v1.0, February 2007
13-3