Configure Pool; Configure Timeout - IBM BladeCenter S SAS RAID Controller Module Installation And User Manual

configure pool

The configure pool command allows of user to change the owner controller for a
group from CLI. This command must be run on a survivor controller. The other
controller must be in service mode.
Command arguments:
<CLI> configure pool -name [POOLNAME] -changeowner
-help option
COMMAND-HELP: configure pool
This command is used to change the owner controller for a group from CLI.
This command must be run on a survivor controller. The other controller must be
in service mode.
Usage
POOLNAME
Examples:
<CLI> configure pool -name p1r5 -changeowner
Current Machine Local Time: 02/07/2013 11:04:44 AM
Error : Change pool ownership command failed
Reason: Controller state is not valid for this request
Note: One of controller must be in survivor mode.
<CLI> shutdown -ctlr 1 -state servicemode
Current Machine Local Time: 03/04/2013 01:22:51 PM
Shutdown Command accepted
<CLI>configure pool -name p1r5 -changeowner
Current Machine Local Time: 03/04/2013 01:45:45 PM
Change pool ownership command successful

configure timeout

The configure timeout command displays and sets the session timeout for the
command line interface. When the configured timeout period is reached, the
system automatically closes the CLI session.
By default, CLI session timeout is disabled. The minimum timeout period is two
minutes (120 seconds). To disable CLI session timeout after you have configured it,
use the -set option and specify "00" for HR, MIN, and SEC.
An error appears if you issue the -set option while the list is empty or if the
timeout value is invalid.
Command arguments:
<CLI> configure timeout -[get | set <HR:MIN:SEC> | help]
-help option
64
IBM SAS RAID Controller Module: Installation and User's Guide IBM BladeCenter S SAS RAID Controller Module
10 105 Off Masked ArtsTime %<AltString:1=initialized:2=updated> - previous value
11 110 Off Masked API requested %<AltString:1=ctlr1:2=ctlr2:3=ctlrs 1&2> to
: configure pool -name [POOLNAME] -changeowner.
: Name of the pool that needs to change the owner controller.
was %<TimeDate>
shutdown and %<AltString:1=power off:2=enter service mode>