IBM BladeCenter S SAS RAID Controller Module Installation And User Manual page 57

you are using the default IP address your management system (the
computer you are using to manage your IBM BladeCenter S components)
must be physically connected through an Ethernet cable to the Advanced
Management Module .
Note: The default IP address for the Advanced Management Module is
192.168.70.125.
b. Enter the username and password.
v The default username is: USERID
v The default password is: PASSW0RD (the sixth position is the numeral
zero)
c. When prompted for the Inactive session timeout value, select no timeout.
Note: Remember to log out when you have completed your session. If you
do not log out, the system shows an error the next time you try to log in.
2. From the main menu, select the Ethernet module and choose Advanced
Configuration.
3. Select Start Telnet Session.
4. Type cfg and press Enter to open the configuration menu.
5. Type group and press Enter to open the group menu.
6. Select the appropriate group number at the prompt
7. Type igmp at the selected group menu to change the IGMP setting.
>> Group 1# igmp
Current Enable/Disable IGMP snooping on current group: enabled
Enter new Enable/Disable IGMP snooping on current group [d/e]:
8. Press d to disable IGMP snooping.
Disabling IGMP snooping through a web session
1. Log into the Advanced Management Module:
a. Enter the IP address of the Advanced Management Module into the Web
browser URL field. If you have the Advanced Management Module
connected to your network, log in using the network IP assigned to it. If
you are using the default IP address your management system (the
computer you are using to manage your IBM BladeCenter S components)
must be physically connected through an Ethernet cable to the Advanced
Management Module .
Note: The default IP address for the Advanced Management Module is
192.168.70.125.
b. Enter the username and password.
v The default username is: USERID
v The default password is: PASSW0RD (the sixth position is the numeral
zero)
c. When prompted for the Inactive session timeout value, select no timeout.
Note: Remember to log out when you have completed your session. If you
do not log out, the system shows an error the next time you try to log in.
2. From the main menu, select the Ethernet module from the Advanced
Management Module and select Advanced Configuration.
3. Select Start Web Session.
4. From the navigation panel, select Miscellaneous settings > Uplink/Group.
Chapter 7. Working with storage pools and volumes
47