Table of Contents
Advertisement
v
Example:
<CLI> expand –volume Grp1:vol1 –add 10%
Volume 'vol1' on pool 'Grp1' has been expanded. The new capacity is 34 GB.
initialize
The initialize command performs a task that overwrites and formats the
metadata area on the drive before removing the drive from the system.
Important: This command produces a destructive procedure causing complete
data loss. Use this command only if your intention is to irrevocably erase all disk
data.
Command arguments:
<CLI> initialize –drive slotnumber
Where:
v slotnumber - Specifies the drive bay by enclosure number.
Example:
<CLI> initialize –drive 1:3
list killedpaths
The list killedpaths command displays the killed drive paths information from
the persistent memory. If both paths to a drive are killed, the drive will not show
up in the list drive response.
Command arguments:
<CLI> list killedpaths [-ctlr [0|1]]
Where:
v -ctlr specifies the path to act on. The default is both the ctlr 0and ctlr 1
Example:
<cli> list killedpaths [-ctlr [0|1]]
Current Machine Local Time: 08/26/2008 03:20:14 PM
| E:T:S |
|_______________________________________________________________________________|
|
|
|
|
|
|
|_________|_____________________|_______________________|_______________________|
88
IBM SAS RAID Controller Module: Installation and User's Guide IBM BladeCenter S SAS RAID Controller Module
[MB|GB|%] - Defines incremental capacity in MB, GB, or as % of total remaining
drive pool capacity.
paths.
_______________________________________________________________________________
DriveDN
1:2:0|
3:5000c5000a832023|
1:4:0|
3:500000e0177202d0|
1:3:0|
3:5000c5000a83b72f|
1:2:0|
3:5000c5000a832023|
1:4:0|
3:500000e0177202d0|
1:3:0|
3:5000c5000a83b72f|
| Word-Wide Node Name | Word-Wide Port Name |
5000c5000a832021|
500000e0177202d2|
5000c5000a83b72d|
5000c5000a832022|
500000e0177202d3|
5000c5000a83b72e|
5000c5000a832021|
500000e0177202d2|
5000c5000a83b72d|
5000c5000a832022|
500000e0177202d3|
5000c5000a83b72e|
Advertisement
Table of Contents
Troubleshooting
