Chapter 3. Understanding The Telnet Interface; Establishing A Telnet Session To Raid Controller - IBM BladeCenter S SAS RAID Controller Module Installation And User Manual

Chapter 3. Understanding the Telnet interface

You can establish a Telnet session to retrieve information or to configure settings
using the command line interface.
You can perform a variety of installation and connectivity management tasks
through an Ethernet connection using this interface.
You can access the Telnet interface in one of two ways:
v Advanced Management Module
v Use the Command Line Interface on a network management workstation

Establishing a Telnet session to RAID Controller

You can establish a Telnet session using various methods. This topic describes how
to establish a Telnet session to the RAID Controller using the Advanced
Management Module.
Before you begin
About this task
To establish a Telnet session to the RAID Controller using the Advanced
Management Module complete the following steps:
Procedure
© Copyright IBM Corp. 2008, 2013
1. Point your browser to http://xxx.xxx.xxx.xxx, where xxx.xxx.xxx.xxx is the
IP address of the Advanced Management Module interface. The Enter
Network Password window opens.
If you have the Advanced Management Module connected to your network,
log in using the network IP assigned to it. If you are using the default IP
address your management system (the computer you are using to manage
your IBM BladeCenter S components) must be physically connected through
an Ethernet cable to the Advanced Management Module .
Note: The default IP address for the Advanced Management Module is
192.168.70.125.
2. Enter the initial default user ID, USERID for the User Name. The user ID and
password are case sensitive.
3. Enter the initial default password, PASSW0RD (the sixth character is a zero) for
the Password and click OK. The Welcome window opens.
4. Select the timeout value of this Web session for the Inactive session timeout
value and click Continue. The Advanced Management Module window
opens.
5. Select I/O Module Tasks > Configuration. The I/O Module Configuration
window opens.
6. Click the link for either the connectivity module in I/O module bay 3 or in
I/O module bay 4.
7. From the Current IP Configuration for RAID Controller Subsystem section,
click Advanced Configuration. he Advanced Configuration window opens.
17