Configure Access - IBM BladeCenter S SAS RAID Controller Module Installation And User Manual

<CLI> commparams –get
Switch Ip Address Information :

configure access

Use the configure access command to set or display configurable access protocols
(SSH and Telnet).
An error occurs if you issue the -set option while the list is empty.
Note: If you disable both SSH and Telnet access protocols, you must reset the
RAID controller back to the factory defaults to re-enable both access protocols. For
instructions on resetting the RAID controller, see"How to reset the SAS RAID
controllers to the factory defaults" on page 183.
Command argument:
configure access -[get | set -enable|disable [SSH|TELNET] | help]
Examples:
<CLI> configure access -get
Current Machine Local Time: 09/16/2011 04:28:38 AM
_____________________________________________
|
|____________________|_______________________|
|
|
|____________________|_______________________|
<CLI> configure access -set -disable telnet
<CLI> configure access -get
_____________________________________________
|
|____________________|_______________________|
|
|
|____________________|_______________________|
62
IBM SAS RAID Controller Module: Installation and User's Guide IBM BladeCenter S SAS RAID Controller Module
Ctlr0
IP ADDRESS 192.168.75.16
GATEWAY 192.168.75.1
NETMASK 255.255.255.0
VLAN tag
VLAN tag insert
Ctlr1
IP ADDRESS 192.168.75.18
GATEWAY 192.168.75.1
NETMASK 255.255.255.0
VLAN tag
VLAN tag insert
Switch Ip Address1
Switch Ip Address2
Access Protocol |
TELNET|
SSH|
Access Protocol |
TELNET|
SSH|
Port0
0d
0d
Port0
0d
0d
:
:
Status |
ENABLED|
ENABLED|
Status |
DISABLED|
ENABLED|
Port1
192.168.75.17
192.168.75.1
255.255.255.0
0d
0d
Port1
192.168.75.19
192.168.75.1
255.255.255.0
0d
0d