Removing The Bezel - IBM System x3300 M4 Installation And Service Manual

Removing the bezel

To remove the bezel, complete the following steps:
1. Read the safety information that begins in "Safety" on page vii and
2. Turn off the server (see "Turning off the server" on page 24) and all attached
3. Unlock the left-side cover, using the key that comes with the server.
4. Open the bezel from the release point on the left edge of the bezel, and remove
40
System x3300 M4 Type 7382: Installation and Service Guide
"Installation guidelines" on page 36.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
Note: You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.
the bezel away from the server.