Removing A Pci-X Riser-Card Assembly - IBM System x3300 M4 Installation And Service Manual

11. Reinstall the ServeRAID adapter (see "Installing an adapter" on page 79)
12. Close and lock the left-side cover (see "Installing the left-side cover" on page
13. Reconnect the external cables and power cords; then, turn on the attached
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 104.

Removing a PCI-X riser-card assembly

To remove a PCI-X riser-card assembly, complete the following steps:
1. Read the safety information that begins in Safety and "Installation guidelines"
2. Turn off the server (see "Turning off the server" on page 24) and all attached
3. Disconnect all external cables and power cords.
4. Carefully turn the server on its side so that it is lying flat, with the cover facing
5. Unlock and remove the left-side cover (see "Removing the left-side cover" on
6. Remove the adapter if one is installed on the PCI-X riser-card assembly (see
7. Press the release latch that secures the PCI-X riser-card assembly from the rear
372
System x3300 M4 Type 7382: Installation and Service Guide
108)
devices and turn on the server.
on page 36.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
up.
Attention: Do not allow the server to fall over.
page 39)
"Installing an adapter" on page 79).
side of the server chassis.