Installing A Hot-Swap Power Supply - IBM System x3300 M4 Installation And Service Manual

13. Reconnect the power cable from the RAID battery to the ServeRAID adapter,
14. Reinstall the fan assembly (see "Installing the fan assembly" on page 105).
15. Reinstall the air baffle (see "Replacing the air baffle" on page 336).
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 104.

Installing a hot-swap power supply

The following notes describe the type of power supply that the server supports
and other information that you must consider when you install a power supply:
v To confirm that the server supports the power supply that you are installing, see
v Before installing an additional power supply or replace a power supply with one
v The server comes with one hot-swap 12-volt output power supply that connects
v Power supplies in the server must be with the same power rating or wattage to
v Power supply 1 is the default/primary power supply. If power supply 1 fails,
v The user can order an optional power supply for redundancy.
v These power supplies are designed for parallel operation. In the event of a
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power source.
Statement 8
100
System x3300 M4 Type 7382: Installation and Service Guide
if you have removed it.
http://www.ibm.com/systems/info/x86servers/serverproven/compat/us/.
of a different wattage, the user may use the IBM Power Configurator utility to
determine current system power consumption. For more information and to
download the utility, go to http://www-03.ibm.com/systems/bladecenter/
resources/powerconfig.html
to power supply bay 1. The input voltage is 100 - 127 V ac or 200 - 240 V ac
auto-sensing.
ensure that the server will operate correctly.
you must replace the power supply with the same wattage immediately.
power-supply failure, the redundant power supply continues to power the
system. The server supports a maximum of two power supplies.