Server Features And Specifications - IBM System x3300 M4 Installation And Service Manual

Server features and specifications

The following information is a summary of the features and specifications of the
server. Depending on the model, some features might not be available, or some
specifications might not apply.
Table 1. Server features and specifications
Microprocessor (depending on the
model):
v Supports up to two Intel Xeon
EN E5-2400 series multi-core
microprocessors with integrated
memory controller (IMC) and
Quick Path Interconnect (QPI)
architecture
v Up to 20 MB Last Level Cache
(LLC)
v One QuickPath Interconnect (QPI)
link speed up to 8 Giga Transfers
(GT) per second
v Three memory channels DDR3 per
microprocessor on the system
board that supports two DIMMs
per channel
Note:
v Use the Setup utility program to
determine the type and speed of
the microprocessors.
v For a list of supported
microprocessors, see
http://www.ibm.com/systems/
info/x86servers/serverproven/
compat/us/.
Fans:
v The server comes standard with
two speed-controlled fans for
one-microprocessor configuration
(including one redundant fan)
v Supports up to four fans with two
microprocessors installed
(including one redundant fan)
6
System x3300 M4 Type 7382: Installation and Service Guide
Memory:
v Slots: 6 DIMM connectors (12
DIMM connectors when the
™
microprocessor 2 expansion board
is installed
v Minimum: 2 GB
v Maximum: up to 384 GB (when the
microprocessor 2 expansion board
is installed)
– 32 GB using unbuffered DIMMs
(UDIMMs)
– 192 GB using registered DIMMS
(RDIMMs)
– 384 GB using load reduction
DIMMs
v Type:
– 1066, 1333 or 1600 MHz
– Single-rank, Dual-rank or
Quad-rank DDR3
– UDIMM/RDIMM/Load
reduced DIMM (LR-DIMM for
Ref1), up to 32 GB
v Supports:
– UDIMM: 2 GB or 4 GB
– RDIMM: 2 GB, 4 GB, 8 GB, 16
GB, or 32 GB (when available)
– LRDIMM: 16 GB or 32 GB
(when available)
Drive:
v Diskette: External USB hard disk
drive
v Supported hard disk drive (HDD):
– Four 3.5-inch HS/SS SATA HDD
in default (can be upgraded to
eight 3.5-inch Hot swap/Simple
swap SATA HDD via FoD key)
– Eight 2.5-inch Hot swap
SAS/SATA HDD in default (
can be upgraded to sixteen
2.5-inch Hot swap SAS/SATA
HDD via optional hardware
upgrade kit)
Note:
v LSI C105 ServeRAID only support
SATA HDD models
v LSI C105 not support VMware
v The system board does not support
parallel IDE/ATA interface. No
floppy disk Interface connector and
no embedded floppy disk drive is
supported
Optional SATA optical drives:
v Two Patsburg SATA ports for:
– DVD-ROM
– Multi-Burner (Rambo)