IBM System x3300 M4 Installation And Service Manual page 364

6. Replace the filler panel into the empty drive bay.
7. Check the hard disk drive status indicator to make sure that the hard disk
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 104
Replacing a 3.5-inch hot-swap hard disk drive:
Before replacing a 3.5-inch hot-swap hard disk drive, read the following
information:
v Inspect the drive tray for signs of damage.
v To maintain proper system cooling, do not operate the server for more than 10
v You do not have to turn off the server to install hot-swap drives in the hot-swap
To replace a 3.5-inch hot-swap hard disk drive, complete the following steps.
346
System x3300 M4 Type 7382: Installation and Service Guide
drive is operating correctly.
After you replace a failed hard disk drive, the green activity LED flashes as the
disk spins up. The yellow LED turns off after approximately 1 minute. If the
new drive starts to rebuild, the yellow LED flashes slowly, and the green
activity LED remains lit during the rebuild process. If the yellow LED remains
lit, seeChapter 4, "Troubleshooting," on page 139 for more information.
Note: You might have to reconfigure the disk arrays after you install hard disk
drives. See the RAID documentation on the IBM website at
http://www.ibm.com/systems/support/ for information about RAID adapters.
minutes without either a drive or a filler panel installed in each drive bay.
drive bays.
1. Read the safety information that begins "Safety" on page vii and "Installation
guidelines" on page 36