IBM System x3300 M4 Installation And Service Manual page 362

v You do not have to turn off the server to install hot-swap drives in the hot-swap
To replace a 2.5-inch hot-swap hard disk drive, complete the following steps:
1. Read the safety information that begins "Safety" on page vii and "Installation
2. Unlock the left-side cover.
3. Open the bezel (see "Removing the bezel" on page 331)
4. Remove the existing 2.5-inch hot-swap hard disk drive (see "Removing a
5. Touch the static-protective package that contains the 2.5-inch hot-swap hard
6. Make sure that the tray handle is open; then, install the hard disk drive into the
7. Rotate the drive handle until the drive is seated in the hot-swap bay and the
344
System x3300 M4 Type 7382: Installation and Service Guide
drive bays. However, you must turn off the server when you perform any steps
that involve installing or removing cables.
guidelines" on page 36
Attention: Static electricity that is released to internal server components
when the server is powered-on might cause the server to halt, which might
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
Note: You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.
2.5-inch hot-swap hard disk drive" on page 342).
disk drive; then, remove the 2.5-inch hot-swap hard disk drive from the
package.
hot-swap bay.
release latch clicks into place.
Note:
a. After you install the hard disk drive, check the disk drive status LEDs to
verify that the hard disk drive is operating correctly.