IBM System x3300 M4 Installation And Service Manual page 197

Table 18. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
806f0108-0a01xxxx The Power Supply n
806f0108-0a02xxxx has failed. (n =
power supply
number)
806f0109-1301xxxx The Power Supply n
has been Power
Cycled. (n = power
supply number)
806f0223-2101xxxx Powering off system
%1 initiated by %2
(%1 =
CIM_ComputerSystem.ElementName)
(%2 =
CIM_Watchdog.ElementName)
806f0308-0a01xxxx The Power Supply n
806f0308-0a02xxxx has lost input. (n =
power supply
number)
Error Power supply n
has failed. (n =
power supply
number)
Info This message is for
the use case when
an implementation
has detected a
Power Unit that
has been power
cycled.
Info This message is for
the use case when
an implementation
has detected a
Poweroff by
Watchdog has
occurred.
Info Power supply n
AC has lost. (n =
power supply
number)
1. Reseat power supply n.
2. If the power-on LED is not lit and
the power-supply error LED is lit,
replace power supply n for both
hot-swap power-supply systems
and fixed power-supply systems.
3. If both the power-on LED and the
power-supply error LED are not lit:
v Use IBM power configurator
utility to determine current
system power consumption. For
more information and to
download the uility, go to
http://www-03.ibm.com/
systems/bladecenter/resources/
powerconfig.html
v For hot-swap power-supply
systems, follow actions listed in
"Power problems" on page 289
and "Solving power problems"
on page 296.
(n = power supply number)
No action; information only.
No action; information only.
1. Reconnect the power cords.
2. Check power supply n LED.
3. See "Power problems" on page 289
and "Solving power problems" on
page 296 for more information.
(n = power supply number)
Chapter 4. Troubleshooting
179