Table of Contents
Advertisement
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the server without
v Take additional care when handling devices during cold weather. Heating reduces
Removing the cover and bezel
Complete the following steps to remove the cover and bezel (with the server out of
the rack):
1. Read the safety information beginning on page v, and "Installation guidelines" on
2. Turn off the server and all attached peripheral devices. Disconnect all power
3. Lift the cover release latch. The cover slides to the rear approximately 13 mm
4. Slide the cover back, and lift the cover off the server.
5. Press in on the USB option tray (below hard disk drive bay 1) to release it and
8
IBM Eserver 325 Type 8835: Installation Guide
metal part of the server for at least 2 seconds. This drains static electricity from
the package and from your body.
setting down the device. If it is necessary to set down the device, put it back into
its static-protective package. Do not place the device on your server cover or on
a metal surface.
indoor humidity and increases static electricity.
page 7.
cords; then, disconnect all external signal cables from the server.
(0.5 inch).
Attention:
For proper cooling and airflow, replace the cover before turning on
the server. Operating the server for extended periods of time (more than 30
minutes) with the cover removed will damage server components.
slide the tray out until it stops; then, press the retention clip at the bottom rear
of the tray and remove the tray from the server.
Captive screws
Bezel retention
tabs
Bezel
retention
tabs
Retention
clip
USB option tray
Advertisement
Table of Contents
