Replacing A Sas/Sata Hdd Option - IBM System x3300 M4 Installation And Service Manual

12. Connect power and signal cables to the drive and the connectors on the
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 104

Replacing a SAS/SATA HDD option

Note: You must turn off the server before replacing a SAS/SATA 8 Pac HDD
option.
To remove a SAS/SATA 8 Pac HDD option, complete the following steps:
1. Read the safety information that begins in Safety and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the bezel (see "Removing the bezel" on page 331
4. Remove the left-side cover (see "Removing the left-side cover" on page 39
5. Pull the hard disk drives and filler panels out of the server slightly to
6. Remove the 2.5-inch hot-swap SAS/SATA hard disk drive backplane (see
You can install an IBM System x3300 M4 Hot-swap SAS/SATA 8 Pac HDD option
in the server. See http://www.ibm.com/systems/info/x86servers/serverproven/
compat/us/ for a list of supported optional devices. To order a SAS/SATA 8 Pac
HDD option, contact your IBM marketing representative or authorized reseller.
To install a SAS/SATA 8 Pac HDD option, complete the following steps:
356
System x3300 M4 Type 7382: Installation and Service Guide
system board (see "Internal Cable Routing and Connectors" on page 47)
on page 36.
all external cables.
disengage them from the hard disk drive backplane.
Replacing the hot-swap drive backplane
1. Read the safety information that begins in Safety and "Installation guidelines"
on page 36.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.