IBM System x3300 M4 Installation And Service Manual page 196

Table 18. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
80010202-0701xxxx Numeric sensor
Planar 12V going
low (lower critical)
has asserted.
80010002-0701xxxx Numeric sensor
Planar VBAT going
low (lower
non-critical) has
asserted.
80010202-0701xxxx Numeric sensor
Planar VBAT going
low (lower critical)
has asserted.
806f0008-0a01xxxx The Power Supply
806f0008-0a02xxxx (Power Supply n)
presence has been
added to container.
(n = power supply
number)
806f0009-1301xxxx The Power Supply
(Power Supply n)
has been turned off.
178
System x3300 M4 Type 7382: Installation and Service Guide
Error A lower critical
sensor going low
has asserted.
Warning A lower critical
sensor going low
has asserted.
Error A lower critical
sensor going low
has asserted.
Info Power supply n
has been added. (n
= power supply
number)
Info This message is for
the use case when
an implementation
has detected a
Power Unit that
has been Disabled.
1. Check power supply n LED.
2. Remove the failing power supply.
3. Use the IBM Power Configurator
utility to determine current system
power consumption. For more
information and to download the
utility, go to http://www-
03.ibm.com/systems/bladecenter/
resources/powerconfig.html
4. For hot-swap power-supply
systems, follow actions listed in
"Power problems" on page 289 and
"Solving power problems" on page
296.
5. (Trained technician only) Replace
the system board.
(n = power supply number)
Replace the system battery (see
"Removing the system battery" on page
375 and "Replacing the system battery"
on page 377).
Replace the system battery (see
"Removing the system battery" on page
375 and "Replacing the system battery"
on page 377).
No action; information only.
No action; information only.