IBM System x3300 M4 Installation And Service Manual page 203

Table 18. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
806f0607-0301xxxx An SM BIOS
806f0607-0302xxxx Uncorrectable CPU
806f0607-2584xxxx complex error for
Processor n has
asserted. (n =
microprocessor
number)
806f0807-0301xxxx The Processor CPU n
806f0807-0302xxxx has been disabled. (n
= microprocessor
number)
806f0807-2584xxxx The Processor for
One of the CPUs has
been disabled.
806f0807-2584xxxx The Processor for All
CPUs has been
disabled.
Error The system
management
handler has
detected an
internal
microprocessor
error.
Info A processor has
been disabled.
Info A processor has
been disabled.
Info A processor has
been disabled.
1. Make sure that the installed
microprocessors are compatible with
each other (see "Replacing a
microprocessor and heat sink" on
page 418 for information about
microprocessor requirements).
2. Update the server firmware to the
latest level (see "Updating the
firmware" on page 111).
3. (Trained technician only) Replace
the incompatible microprocessor
(see "Removing a microprocessor
and heat sink" on page 416 and
"Replacing a microprocessor and
heat sink" on page 418).
1. Update the firmware (UEFI and
IMM) to the latest level.
2. Run the DSA program.
3. Reseat the adapter.
4. Replace the adapter.
5. (Trained technician only) Replace
microprocessor n. 6. (Trained
technician only) Replace the system
board. (n = microprocessor number)
1. Update the firmware (UEFI and
IMM) to the latest level.
2. Run the DSA program.
3. Reseat the adapter.
4. Replace the adapter.
5. (Trained technician only) Replace
microprocessor n. 6. (Trained
technician only) Replace the system
board. (n = microprocessor number)
1. Update the firmware (UEFI and
IMM) to the latest level.
2. Run the DSA program.
3. Reseat the adapter.
4. Replace the adapter.
5. (Trained technician only) Replace
microprocessor n. 6. (Trained
technician only) Replace the system
board. (n = microprocessor number)
Chapter 4. Troubleshooting
185